Verify Graphics Doing Funky Stuff

[huskermcdoogle]

Pre X6 Didn't really notice this ever. Can't say that I remember this ever happening. Though I don't use verify much, it is handy for collision detection in the form of violating final geometry. But my stl goes batty and grows like a crystal , wondering if anyone else is experiencing this or if I need to go after a new video card.

 

I have an ATI card which as it may not usually be suggested has worked well for me up to now. I am going to install X6 on my other workstation and try it out over there on an nvidia card....

 

 

 

 

P.S. I get this with stock model as well from time to time.

 

Husker

[huskermcdoogle]

Same file with less efficient toolpathing pre my update to x6 does the same thing in x5, just doesn't end in a big mess....

[K2csq7]

Did you try opening up the tolerances in verify?

[Guest]

Do you have the hardware acceleration in the config disabled?

 

That is typical of many ATi based installtions

[huskermcdoogle]

Did you try opening up the tolerances in verify?

 

That was about as open as it gets.... I think I figured it out. Ended up being a graphics driver issues. I reverted a few drivers back and it doesn't do it any more. So i am guessing that was it. The driver installed was the Dell Solidworks suggested driver.... Now I think I am on the stock dell driver. Gonna go ahead and get the non dell bastardized driver for solidworks and give that a shot.