Taping cycle g-code output for mill

[mig]

Hi,

What parameters i have to change to make feed in taping cycle as per revolution?

For some reason on one of our machine output of feed - 0 . Looks like this is not post issue .

Thank you in Advance

[Guest CNC Apps Guy 1]

In your post there may be an IPR switch for tapping. WHat post are you using or rather, what did your post originate as?

 

 

[mig]

In your post there may be an IPR switch for tapping. WHat post are you using or rather, what did your post originate as?

this is conveted post from x3 i I thing .

I tryed this post on another computer ,seems to be working fine . Looks Like this is .mmd problem .

Some one from our guys made this mess. I thing must be some where setting for feed output in taping cycle.

[Guest CNC Apps Guy 1]

What was the post based from? MPMaster? MPFFAN?

[mig]

What was the post based from? MPMaster? MPFFAN?

I guess MPFan or MPOkuma. Don't Remamber to be honest.

[Guest CNC Apps Guy 1]

In your tap cycle needs to look like this, or somethign close.

 

ptap$            #Canned Tap Cycle
     pdrlcommonb
   #RH/LH based on spindle direction

   pcan1, pbld, n$, "M5", e$
   pcan1, pbld, n$, "M19", e$
   pcan1, pbld, n$, "M33", *speed, e$
       if met_tool$, pitch = n_tap_thds$  # Tap pitch (mm  per thread)
       else, pitch = 1/n_tap_thds$       # Tap pitch (inches per thread)
       pcan1, pbld, n$, *sgdrlref, *sgdrill, pdrlxy, pfzout, pcout, pindexdrl,
       prdrlout, *pitch, *peck1$, !feed, strcantext, e$
      pcom_movea

 

HTH