Operations manager just went bonkers wide when docked

[huskermcdoogle]

So my operations manager just went ultra wide when docked. I can't find the right side of it to reduce its size. Can't use a default toolbar state to get it back. I am stuck here. Don't want to run it undocked for a long time. Don't want to restart it.

 

X6 MU1

 

 

Where can I manually change a value to get it back?

 

Husker

[huskermcdoogle]

Ok figured it out. Couldn't stop until I got it.. Dock it on the right side, then shrink it using the left side of the window. Took about 30 full slides across the screen.

 

Still confused how this happened.

 

Husker

[Thee Rickster ™]

I have seen that, kinda funny though.

[Aeroguy]

OMG, this has just happened to me and it is driving me friggin crazy. I can"t seem to get my operations manager back to normal after it went full screen for some reason.

Anyone got any ideas how to get it back to it's original state?

[NOTW Programmer]

Reset dialog windows in Mastercam Applet.

[Aeroguy]

Sorry, thats not working out for me either. Anything else I could do?

[Scott Lundin Shopware Inc.]

If you have two monitors do this:

 

 

Switch MCAM to a windowed mode and stretch it across both monitors. Now you will have access to the right side of the OPS MGR and you can shrink it down. The OPS MGR was only extended to the end of the main display, but once extended MCAM in windowed mode, the OPS MGR was extended way past the main display.

[Aeroguy]

Awesome, that worked aces. Thanks:)