Where is center helix on point in optirough?

[tedly]

I can't find center helix on point when using optirough in X5MU1. It is in help file to tell us what this option is for.

[crazy^millman]

When you are picking your geometry from the get in the Toolpath/surface selection dialog box at the bottom there is the Approximate starting point.

 

Then once you are in the toolpath if you look over to the right there is the same things listed on the toolpath type.

 

Then if it is not selected it will then prompt you to pick one at the end if you tried to pick one and failed.

[tedly]

It is ok if you have one point. What happen when you have multiple points. My actuall question is why do they have "center helix on point" in help but not in working unit?