horizontal milling at different angles

[LiamBeans]

I have been using an agregate to do all of my horizontal milling. Whenever i program it, I use mc9 because thats they used to use at my job. I have since upgraded to x5 and can do my horizontal milling and boring, but when it comes to angles that aren't 90, 180, 270, and 0 I have no luck. I can draw the path, but it comes out to the view that i selected in. Any suggestions for ways around this? I was in a jam today and just physically drew a tool path. Any help or suggested resource is appreciated!

[TheePres]

If you would like to share a sample, I can show you how i approach horizontal work.

[LiamBeans]

Do you want a drawing or an mcx? Either way, thanks!

[Brando]

hey liam if you need a hand up there im from glen rock would be glad to help on site, i program for baxis hmcs all the time @eagle

[LiamBeans]

That would be awesome. I just need to figure this one thing out. I don't know if your ever in Red Lion, but if not, I have MCAM on my laptop with all of my posts. I'll buy you lunch somewhere. My email is [email protected].

[Brando]

i just sent you an email