Transform/Mirror Issue

[chrisdavala]

I am trying to mirror a 5 axis curve path. I am using type-mirror / method-coord / cut direction-reverse order. i have 3 curves each selected as single entities and each feeding the same direction. When i do a transform/mirror it changes the it should replicate what i have in reverse so i assume. However, it mirrors 2 of the curves perfectly but the 3rd curve cuts the wrong direction as if its not reversing the cut order on that 1 chain. I can check create new operations and reverse direction on that 1 line and it runs fine but i don't get why it only screws up 1 of them. Any thoughts?

[crazy^millman]

I have always stayed away from this. I understand it suppose to do much more than in the past, but I always mirror my geometry and make toolpaths off of that verse the method you are doing.

 

HTH

[Jayson Kramer]

I agree, this dose alwas turn out right. Mirroroing is diffrent them transforming a 5 axis path.