torx wrenches with tourque convertors

[within a thou]

We have a problem with operators over torquing and under torquing insert screws. I remeber seeing a set of torx wrenches that had lights inside so as soon as the right tourque was applied they would light up but can't seem to find them anywhere. Does anywhere know where I could get these or any other products that would laso fit the bill.

[EX-wccprogrammer]

You mean these?

 

http://mfgnewsweb.com/archives/general_editorials/may07/iscar.htm

[Mick]

Sandvik Coromant does torx wrenches that have click when they reach the required torque. We use them all the time here.

[Del.]

They haven't made a torque wrench yet that my second shift guy couldn't break a workholding vice with.

[within a thou]

Ya those will work thanks guys

[Pilot Plant Supervisor]

The lighted ones I've seen were from Ingersoll. Not sure if they still make them or not.

[Machineguy]

Always 1 He-Man per shop. I think its a requirement !

 

Machineguy

[MinkHollowMach]

Using Wera drivers - purchased from MSC :

 

http://www.mscdirect...?rItem=04457073

 

this one is a T15 -- expensive, but has saved many insert screws.

[Big Fish]

i prefer wiha, just because i've had good luck with them holding up compared to a few other brands i've tried.

 

http://www.wihatools.com/200seri/285serie.htm

 

i can get them through msc at reasonable prices.