X7 SP1 Verify chamfer tool not right

[Tinhman]

Good morning Guys,

Have X7 sp1 installed and run into a little bit problem here.

Just wonder it is just me because i am missing something or some kind of bug.

I just can not verify my chamfer tool.

The graphic just give me a flat cut instead on angle cut.

 

Tinhman

[Ben Wood]

I've seen it happen in previous versions a few times. If I remember right deleting the tool and then creating a new one fixed it.

[RON S]

I had this hapen when I was testing X7 on a file that had worked in X6. I found that the tip dia needs to be .0002 or larger to verify correctly. All my chamfer mills were difined as .0001 tip dia which worked fine in X6 but not in X7. Once I changed it they worked fine.

[Tinhman]

"Tip dia larger .0002 did the trick"

Thanks for your help Sir.

 

Tinhman