Trim Surface

[Thoob]

Hi guys, its been a bit since I have used trim surface options and I am not sure what I am doing to get this proper trim. In the file you can see the surfaced holes extruded past the part. What I'm trying to do is trim the hole surface to the radius of the angle and the thickness of the part. I can't seem to do it. How do I tackle this and what is the procedure I'm missing? Thanks

TRIM HOLES.MCX-6

[K2csq7]

create

surface

trim

to curves. (use partial chain to ensure you make it all the way around the hole)

 

The green curve is the only one I had to re-create (the existing wireframe didn't connect all the way around the hole, I deleted what was there and used "create, curve, at intersection. picked the hole then the fillet.)

 

I was in the right side plane (not sure if that matters...)

[Thoob]

Ahh, ok thank you. I got it. Funny the smallest things can really throw you for a loop. Appreciate it.

[K2csq7]