tool outside sufrace

[duckdogers]

in op3 the backplot shows the tool doing what it is suppose to do.In the verify it shows going out side the surface gouging into the part where I don't want it.It has done it on the machine so I,m trying to figure out why.Anyone have an answer.

[DAN 1313]

its on the third operation correct? I went into the gap settings, changed the motion to smooth and checked on optimize cut order. it fixed it for me.

[duckdogers]

yes third op.I ended up redrawing surface and it seems to have fixed it(don't know why).I don't understand why backplot looked fine but not in verify.Those flowline settings are the ones we use all the time.Did you get the gouge in verify?

[duckdogers]

I just realized my spelling could use some work(tool outside sufrace).Afternoon shift is a killer

[Jayson Kramer]

Try the setting in the picture.

[billb]

Hi, I notice that op #3 has smoothing enabled. You might have X7MU1 installed without the smoothing hotfix. If you disable smoothing in op #3 and regen, does the dogleg rapid gouge in verify go away? If so, consider reinstalling X7MU1 (with the hotfix) or keep disabling smoothing until X7MU2 or X8 is released.

 

Classic backplot doesn't show the dogleg rapids; you can configure X7MU1 to use the new backplot. New backplot shows the dogleg rapid motion (it matches verify).

 

Regards,

Bill