X+ EDITOR FOR XP-PC2 ????

[CADCAM3D5AXIS]

HI ALL

I just did the X9-pc2 update and was wondering if the x+ for pc-1 will work for x9-pc2 i went thru the install and it shows the tool icons in the customize workspace but it will not let me position any of the icons or try to run the app. when i go to move the icons to the tool bar i get the windoze red icon like no way jose .  Any Ideas folks ???

Thanks for any input I shall return later in the am for a fresh look.

:scooter:   time to go

[Mick]

PC2?

 

X9 has been released hasn't it?

[CADCAM3D5AXIS]

Yes it has I was just going by the release version i had downloaded last week which is the release version 18.0.11898.0 so i am wondering why the X+ Editor is not working when it was in the PC1 version. I was looking for any body else who had issues with the app at this point. I had it working in PC 1 but now its not working at least for me at this time. i think a little more tinkering may be the next phase.

Just looking for suggestions .

Thanks

CADCAM

[Tinyfxds]

I deleted it and then downloaded it again and it worked.  I saved my templates in another folder and once I downloaded X+, I put them back where they belong.  Everything is working fine now.