Little help with modeling

[Müřlıń®]

I made a mistake on the .687 dimension on my first try and pulled it off the wrong plane....

 

It is actually not constructed in the plan view. after reworking my projected lines onto the plan view from the 16 degree plane this time,

 

the error on the 11.5 degree 45's was only .0381 degrees....just a few thou....but I rotated the wall to 11.5 degrees anyways...call me picky...

 

 

 

 

 

This is my solution after I corrected my mistake....

 

 

 

 

 

 

i found one questionable issue...the reamed hole appears to be the only thing that is tilted at 1.25 degrees....

 

The print is unclear..

 

There are alot of blurred lined that make it look like the 1.062 CB and the .375 bushing hole might also be on 1.25 degrees...

 

Again, unclear I would be calling my customer if I had this job to do.

 

Do not use this as your model as it may or may not be correct.

 

This is just for educational purposes only.