Haas st10y setup

[Stephen]

What is the best code for the return to tool change position? My post outputs G28 U0 V0 W0. The V0 causes alarm 357 AUX AXIS DISABLED.

 

A plain G28 causes the return to get in the path of the tailstock.

 

The other problem is it normal on a new machine to not have the boring/drill tool holders(1" and 1.25") not be on the spindle centerline?

For example, some tool numbers will only dial-in using the Y axis offset. Other tools will dial in at Y0.

 

Thanks,

Steve

[jlw™]

I have all of my lathes set just to G28 U0.

 

That's an easy edit, go in the post and take out the V.

[civiceg]

V is not the address for your Y axis. Look at your manual under G28. 

 

I prefer G53 as it does not cancel your tool offset. 

 

You can adjust the cam locators on the turret to fine tune your OD and drill holders. To get them to clock in at Y0.