HTML setup sheets and Meta Cut Utilities

[RAM1]

Does anyone know of any conflicts the MetaCut Utilities program may cause a HTML setup sheet not to work right ?? I have MasterCam installed on two comuters here , one with MCU installed and one without.. I use a html setup sheet just fine on the computer without MCU , but when I try using it on the computer with MCU , it will not post out the graphical display at all.. Both are configured the same except that one see's .NCI files as unkown file type and the other see's it as a Meta cut file.. Any help would be appreciated

[Roger Peterson]

You can try deleting the association. If it doesn't work and you want the nci to automatically open up into MCU you can always add the association back in.

 

 

HTH

[Allan Brown]

Make sure your NCI destinations don't contain spaces.

[Fig sign]

Metacut utilities is known for adding to the nci tool data through commented text

May be this is an issue .

Have a look on this thread for additional info Metacut utilities

 

HTH