How to select ??? Window, specific color or points

[DCOPE17]

I know where to find the Select All and Select only in Mcam X9 but cannot find it in 2017. Same with the Chain/Window/Polygon selecting too. 

Any help is greatly appreciated .

Dan

[Guest]

Install the Command finder chook available on the CNC Forum

 

BTW, it's all on the floating bar under the main menu bars

Edited June 7, 2017 by Guest

[crazy^millman]

The selection bar in the middle of the graphics screen.

[DCOPE17]

Found the Chain/Window/Polygon in the bar at the top of the graphics screen. I had found that before but couldn't remember where. 

I have not found a way to Select All points or Select All by color. 

Is that in the Chook mentioned above? 

[Guest]

2 minutes ago, DCOPE17 said:

I have not found a way to Select All points or Select All by color. 

Masking is on the right side....

The chook, when you type in a command shows you where and takes you to the command

[DCOPE17]

1 hour ago, JParis said:

Masking is on the right side....

The chook, when you type in a command shows you where and takes you to the command

I'll get working on that tomorrow. Thanks for the help.