Random code at beginning of program when changing post?

[milehighxr]

When I change from one post, say Hurco, to Haas and there is a pocket operation, the first 5 lines of code are correct.Bbut then I get:

/ G91 G28 Z0.
/ G28 X0. Y0.
/ G92 X-9.075 Y10.925 Z-10.3287402

and my work offset is not there. It only happens with a pocket operation, and when changing to my  Haas post from any other post. The other posts are based on the MPMASTER, and the Haas is based on the generic Haas post that comes with Mcam X8. This all in X8.

[Guest]

Check your Misc ints values....# 1 is set to 0 or 1 most likely.....

 

Edited October 5, 2017 by Guest

[milehighxr]

It's set to 2=G54's in the control definition for the Haas.

[Guest]

Look in the operations

[milehighxr]

For some reason the tick box for "set to post values" was not checked on the operation for pocket. I checked it, and it's fixed. Wonder why it wasn't checked...

[Leon82]

Check it in the defaults settings so it will be pre checked on new files or paths

[Leon82]

I believe you can get to it with the exclamation point in the files setting tab. 

 

Someone may have unchecked it then hit the save button to save it to defaults