3d arcs, searched can't find answers

[milehighxr]

I'm programming a surface for a Haas, and no matter what I do it won't spit out any arc moves in the xz, or yz plane. I have it all set up right(or so I think). If I change to my Fadal post, and fumble around with the filter settings I can get arcs. If I go back to the Haas post, and try the same filter settings, it's still all G1. I'm using surface parallel, and setting the cut angle to run the tool up and down the arc(xz or yz planes). Its just a simple arc, but if I change the angle to 90° from the arc, it's all facety. I using .125" ball mill, and .003" step overs.

What am I missing?

[crazy^millman]

Have you checked the CMD and made sure they are turned on there?

[Guest]

I Moved this to the Industrial Forum....this is most likely not a post issue perse....

Can you share a z2g so it includes all the info including your post?

[milehighxr]

12 minutes ago, C^Millman said:

Have you checked the CMD and made sure they are turned on there?

The control definition? What would I be looking for?

[Guest]

[milehighxr]

Thats all turned on, except I have arc break point set to don't break arcs.

[Guest]

It's not there then...I'd still ask for a z2g.....just slinging things at the wall otherwise

[milehighxr]

We played with the filter setting some more, and loosened up the filter tolerance, and made sure it was filtering arcs in all 3 planes. That seems to have fixed the code. Now to see how facety it is...