How do I put an optional stop in a fanuc post processor

[deadeye460]

I am trying to put an optional stop into a post processor between tool changes. I can type the M01 into the spot where I want it, after the (SAW OFF) command, but the machine ignores it.

Any help would be greatly appreciated. Thanks. Deadeye. 

$ENDIF
$IF PIERCE = 1
$LET PIERCE = 0
$GOTO 99
$ENDIF
$LET FRATC = 1
$IF [T] = 1 ''JET
$LET HNUM = HNUMJET
M24 (SAW OFF)(JOHNS JAN. 17 2018)
M1
G43H0Z0
G91
G17 X0 Y0
G90
[WCSJET]the spot I believe it's needed but the machine ignores it. Thank you. Deadeye.

[htm01]

you have to push the opt stop button on the machine too

[deadeye460]

Thank you for the prompt reply. I checked and there isn't  an opt stop button on the machine. Machine is a Northwood Saw/jet. Thanks again.

[htm01]

the meaning of opt stop is optional, there has to be a setting or button to turn it on and off, unless your machine does not have it at all

[deadeye460]

Found it, thank you for your help htm01