EDM start point

[mirek1017]

Good morning .I want cut punch on my EDM and I have problem with my start point  on my 2018 .I  got the same settings on X9  and working fine .Can someone pint me what settings is wrong ???

 

thanks 

T10-316 DET 101.mcam

[pullo]

There is no separate  cutoff or  threading point  in 2018 . It is just a point .

SO when you start the  chaining  for the punch cut :

1. first choose as the chaining mode :Point 

2 then chain your punch 

 

and now if you want to be fancy than select the point and choose  HOME -Analyze  Entity and then you can change  your point style to look  like a threading  point or cut off point

 

[mirek1017]

thanks for your reply .I try this ,and do the same thing .Wont start from center .I do the same on X9 and working fine .I missing sane setting 

[pullo]

You said punch , so I started from the outside .... I'll do the file again from the inside....

[pullo]

T10-316 DET 101 2.mcam 

is this what you wanted (second op) ?

[mirek1017]

on 2nd oper I want to start from outside .Your file show good toolpath ,when I open on my mcx wont to start from center 

[pullo]

T10-316 DET 101 3.mcam

op 3 ok ?

[mirek1017]

nop,I want to cut out side contour and start from out side  point