MC4SW2018 Lathe stock flip not regenerating

[Mark VIII]

I am having an issue (one of many) with MC4SW Lathe. The Stock Flip operation will not regenerate. After creating the op I get the message "At least 1 operations was marked dirty". When I try to regen, I get the same issue. Has anyone else seen this? 

[Ewood42]

20 minutes ago, Mark VIII said:

I am having an issue (one of many) with MC4SW Lathe. The Stock Flip operation will not regenerate. After creating the op I get the message "At least 1 operations was marked dirty". When I try to regen, I get the same issue. Has anyone else seen this? 

Do you have any manual edits to your toolpaths (locked operations) on op 1? Locked operations don't show as dirty unless you expand them.

[Mark VIII]

No, I do not.

[Ewood42]

Check the op to make sure all your settings are good, and be sure your stock is properly defined. I don't use it much, so that's about all I got.

[Mark VIII]

Everything appears to be set correctly.

[Ryan Butt CNC Software]

Hi Mark,

This sounds like it may be related to a known issue that we are looking into that's specific to using sketch geometry vs solids. If that's not the case can you send us a copy of the file to [email protected] and we'll take a closer look.

Thanks

[Mark VIII]

Thanks for the replies guys. I am using MC4SW 2018 update 3. Do you know if this has been corrected on 2019?

[Ryan Butt CNC Software]

Not yet but can you confirm you are using sketch geometry. We just want to make sure that is the same issue and not some other unknown issue. If it is I'll a note to the existing defect to help push it up the latter.

[Mark VIII]

Yes. I am using sketch geometry.

[Ryan Butt CNC Software]

OK thanks Mark. I added the note to the existing defect (D-33787).