help with Haas Probing cycle?

[motor-vater]

So I am running a part that requires probing off a bore to maintain true positioning. We were having problems just trying to assume that it located in a fixture well enough. So we used a Haas probing cycle to reset the work offset on each part. The problem I have is the Z move is not protected. I know there has got to be a way to say rapid down to 1 inch  above the part then enter a protected z move to depth?. heres the code we have as of right now. Thanks for any help

T24 M06;

G00 G9O G54 X0 YO;

G43 H24 Z-0.1181;

G65 P9023 A1. D0.312 S54;

[jlw™]

Protected positioning is 9810.

You use it exactly like a G01 move but it would be

G65 P9810 Xpos Ypos Zpos

[jlw™]

See chapter 5:

https://diy.haascnc.com/sites/default/files/Locked/2/Renishaw_Programming_Manual_H_2000_6222_0A_B.PDF