EDM Wire coding different

[killall-9]

Hi Guys

Not sure if this is a POST related issue or software.

My EDM mastercam is producing code for radii in 90deg increments, so if it is a 180 deg cut, it breaks the code up into 2 different arc movements.

I've shown an example of how my mill would produce and my wire.

also how can i scale down the decimal shown from .xxxxx to .xxxx

[nickbe10]

22 minutes ago, killall-9 said:

Not sure if this is a POST related issue or software.

There is a switch in the MD/CD which turns arc breaking on and off. 

Number of decimal places is controlled by the formatting statement assigned to the feedrate.