aaron tabor
-
Posts
57 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by aaron tabor
-
You were right about that thanks for the help.
-
Yeah I ask questions when I don't understand. When everything goes right on mastercam or when I encounter a problem troubleshoot it and figure it out it gives me a sense of accomplishment. I'm learning mastercam with the tutorial books so far I've done the Mill and Lathe essentials tutorial books. Now I'm working on the solids and advanced milling tutorial books. My goal is to keep learning mastercam go through most of if not all of the tutorial books and eventually become mastercam certified.
-
can you tell me why when I try to machine on the front plane its cutting into the part way more than the depth I entered in the linking parameters? example part.emcam
-
For speeds and feeds you can determine good numbers by calculating the chip load correct? Which is IPM/RPMx# of flutes
-
Ok I understand now, once I redo the tutorial I will take your suggestions into consideration, comments, tool holder etc. I probably should have done the whole tutorial before getting ahead of myself and thinking something was wrong.
-
I tried adding a stock model to the original file then re-generated the blend tool path but its still cutting at an angle. Also I can't regenerate the toolpaths on your file but I matched the parameters from your blend operation to mine and it still cuts at an angle I added the current file so feel free to take another look. I appreciate the help tutorial 2 review.emcam
-
I'm following a mastercam advanced milling tutorial, I enter all the parameters the way the books says. But instead of cutting the part even and flat its cutting the part at an angle towards a center point. I am hoping someone can take a look at it and see what could be wrong I tried somethings but could not figure it out. TUTORIAL 2 WIREFRAME_ EXCERCISE with tool paths.emcam
