there is a ! in front of my program get error code poss corrupt program deleate all programs and reload it wont let me deleat any programs or do anything dont know how ! got there or how to get ride of it thanks in advance if you guys know what this could be

yes it was from in house and thank you i will contact him

good afternoon gentelmen just a quick question. a couple of years ago we purchesed the set up sheets My hard drive got smoked was wondering who would i contact to try and get replaced

yes have tried a couple same error

tryied that but still no go looks like time to call my reseller tech support

also i can see the assembly in the preview window

cannot find parasolid data in solid works file but when i open file all me assembly ops show up but when i try to open get the error message

how come i can open a sldprt but cannot open a solid sldasm do i need a differant converter running x2 mr1

Id like to know also

that has happened a couple of times with me also what you have to watch is that when you change size on insert you have to make sure size on holder width is a tad smaller than the size of insert or it will go back to what it was also if you dont get a message "changing this tool will update your operations " and hit ok it will not change

ok for lathe on V9 i just draw half from center line up for tool path now on X2 how do i get it to analyse my lines at dia instead of just fron center line up ex if dia is 2. it cheks 1. and i need to double answer

thank you gentelmen

how do i stop X2 from putting a point at center point of every rad i put in for lathe

arctype is set to "2" but still no go i guess i will just edit until i can call my tech support at the reseller thanks guys

using v9 haas post when i post everything comes out right except my "I" move is reversed + number comes out - and - numbers come out + where can i change this in my post go2 and go3 and k values are correct