Hey Sig, Mori NH4000DCG is a great machine. Send me an email with the specifics that your looking for.

I have, but the boss wants to see it(the machine) tap!

Thanks Mark!

JParis, You have mail.

That’s my next issue. I am running a Mori Seiki DuraVertical 5080. It’s a good size machine but I reading the manual right now to try and figure out there synchronized tapping cycle and hp range.

Thanks John, It is a cutting tap (spiral), programming in metric and only have to go about 70mm deep. I have not visited the forum in a while but what happened to the Patriot's logo? John

I have to push a 30mm x 3.5 tap thru a block of 1018 CRS, any recommendations on speeds and feeds? I'm running a Mori Dura Vertical. I have no experience with metric taps and since this is so large I would like a second, third or fourth opinion. Right now I have it programmed for 2100.0 feed at 600 rpm. Thanks

Has anybody ever had any experience(good or bad) with these machines? OKK Machine Tools. (www.okkcorp.com) I have been told that they are "top of the line Japanese machine tools" Any input would be helpful. Thanks

Thanks Todd.

X2 recieved on 11/16

Im hell with numbers, but that readin and writin get me every time! Thanks Again.

Thanks Mike!

Sorry, I ment run time or cycle time for selectefd operatins.

Does X give a run in back plot?

Yes,I did. Thanks, Gcode!