Turn Master
-
Posts
8 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by Turn Master
-
Op Manager closes 'during' regen paths.
Turn Master replied to Thee Rickster ™'s topic in Industrial Forum
Check your config. file, screen. Could be your problem.
-
quote: I never thought of an ignore for a whole thread.. the ones I'm familiar with just allow blocking individual users.. on one thread Is used to frequent, there was a seriously vile troll carrying on a 3 year conversation with himself.. The entire forum had him on ignore. That wouldn't have been Cliff by any chance, would it?
-
Tool libraries for Mastercam
Turn Master replied to Reijo Heurlin from Zenex Finland's topic in Industrial Forum
Nice, neat, looks well laid out. My only criticism would be that us lathe guys are left out again. -
Every time I try to use it my ID & OD lines usually come out with a slight taper to them when they should be straight.
-
The Mplmaster post is very generic but follows the fanuc programming style. You can use it but it would require a lot of heavy editing to get a useful program. Some of the G & M codes match but watch out for the ones that don't.
-
machine def manager click on properties for c-axis down @ the bottom of the page change c-axis to continuous
-
You don't have to change those values. Haas controls read in tenths so 0265 = .0265
-
Go into your control def. In tolerances change the chordal deviation from .0001 to .0005. Should help your finish quite a bit.
