Go Navy
-
Posts
106 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by Go Navy
-
Good Morning All Please don't take this as Mastercam bashing or Reseller bashing but, How many man hours should we expect to expend working with a reseller writing a post. We have 80+ man hours in this post with no end in sight. Our reseller continues to promise and promise but has yet to show us anything that even comes close to working. When if ever should they come out to our facility and finish the job they started? Thanks for all the input Have a great day Al
-
That did it!!! Thanks you guys are great! First round is on us if your ever up in our area.. Whidbey Island Washington Thanks again Al
-
Good Morning All Here is the easiest question of the day.. Can you move or customize the buttons in Mill version 9.1
-
As you all can see by the material that we are working with America has spared no cost on materials that serve our forces here and abroad. Only with this kind of dedication to quality are our forces able to protect freedom worldwide. Yes, the picture is aluminum it is only a test piece for set up. I appreciate all the input it did help, it was just as simple as going back to the basics and adding a rough cycle.
-
Thanks for the help Works great!!!! Have a great day and Go USA Al
-
Good Morning everyone Here is an easy one. I am trying to program my toolpaths in mill level 3 v9. The difficulty I am having is avoiding my clamps with tool path is there anyway to input clamps so that mastercam can program tool paths that goes around them. Thanks for all the help Al
