mike49107
-
Posts
8 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by mike49107
-
Thank you. I’ll try to test it soon if I can get some time.
-
I know that this is an old thread, but could you please provide more information on how to accomplish this? I have asked my reseller to add this to our post and was told that it is not possible. thank you.
-
Does anyone know what the fix is for these errors? I have found that if I delete the mwVerifierGUI.ini file I can start Mastercam one time without error. Upon closing, a new .ini file is generated and the errors come back. Hopefully someone can help with this. It doesn't seem to have any effect on anything other than being very annoying to click thru the error messages every time. I'll add that this is occurs upon opening.
-
Yeah, it's working. I wasn't even aware of the "Advanced Options".
-
This is all I see:
-
Custom drill cycle for a pin stop?
mike49107 replied to oln20012's topic in Post Processor Development Forum
It works! Thanks again! -
Custom drill cycle for a pin stop?
mike49107 replied to oln20012's topic in Post Processor Development Forum
Colin, thank you for the fix. I am using the MPMASTER. When I get some time, I will modify to your example. -
Custom drill cycle for a pin stop?
mike49107 replied to oln20012's topic in Post Processor Development Forum
I use the point toolpath for pin stops all the time. Posted code is identical to what the OP is looking for. What would I modify in the post to omit the "S0 M5"? The control doesn't like it, and I always seem to forget to remove it from the program before I release it to the floor. Seems to me a simple If/Then type logic would work, but I haven't messed with post modification since X5.
