Mine also works fine!

That happens to me a lot and I can't figure it out either. I just make it big again.

Camdude

What the setting in the machine does it controls the maximun feedrate that the machine can do before overcut. You can completely set the tolerance. Under display press setting once. Hit the page down button once or twice. at the bottom of the screen you will se setting 85 with max corner rounding. See what it is. Try around .005, type that and press write/enter or F1. That should help. This adjustment can be done with the program running, so play with it.

I was wondering when I backplot it I can have it read the P time for a g82 differantly. I know technically it is suppost to be entered in as seconds and not thousandths of a second but I like entering it in my way better. Personal preference. Right now a P60 backplots out a 1 minute, but it posts as the correct time of only a fraction of a second.

We had a power surge blow up the main power card it a power surge. The machine was off but the main breaker on the machine was on. The breaker now always get shut off with the machine.

Set you top of stock to -.0001 below the top of your actual stock and then on depth cuts set it to absolute with the minimun also -.0001 below top. worked for me.

Could you send it to me too.

thanks

Shawn

[email protected]

When I bought Mastercam, I was told if I got mantenance X was free. After I get get X, if patches are free, like I thought they were now, why would I buy maintenacne? Should I buy it when it ends?

Thanks, that worked perfect

Is it possible to change the toolbar buttons at the top to have what I want, where I want?

Is it possible for the material in job setup to be default of aluminum?

Also, when I create an operation, I'll select a tool and the coolant always turns itself off, even though it is on in the parameter page.

Toolfab

Could you make a tapered endmill that had 37 degrees of taper?

It would be nice to have a seperate profile for a thread mill and then you could verify and see the threads getting cut instead of using an end mill.

How do you peck tap in mastercam? Is it a single function or several ops at differant depths?

If this was done, How would you select the stock origin?

What do you mean CoD?

Thanks for all the help.

Completely new, we do mostly small intricate aluminum parts, but always looking at expanding.

We are looking at getting into makeing plastic injection molds and was wondering if anyone had information or books on design characteristic like location of vents or ports, draft angles needed, ect. Any help would be appreciated!

I need to program a part to drill that has a space between the two drilled surfaces, like a piece of tubing. is it possible to drill throught the first, rapid to the second and drill through the third and then rapid out without retracting between drilling motions?

Depending on the type of machine, it may be simple. Haas only need an M06 and it turns off the spindle, turns off coolant, retracts to z height, and changes tools, in that order

Depending on the type of machine, it may be simple. Haas only need an M06 and it turns off the spindle, turns off coolant, retracts to z height, and changes tools, in that order

I had the same problem and called CNC software and they were not aware of it. I guess changing the post would work as long as you remembered to enter everything in right.

Haas can't have a decimal point. a one second pause would be entered in as 1000.

Haas can't have a decimal point. a one second pause would be entered in as 1000.