Timing is too much

[A_learner]

Hi, there I am a student currently learning Mastercam for my semester. The problem that I am asking from all of you, is that when I was finished, the feed time for it was 40 hours ++.  Is there anything I can do about it?

[Leon82]

I have seen tapping and some drilling cycles ad hours to run times before. What is your feed rate, toolpath ect....

[Guest]

3 hours ago, A_learner said:

Hi, there I am a student currently learning Mastercam for my semester. The problem that I am asking from all of you, is that when I was finished, the feed time for it was 40 hours ++.  Is there anything I can do about it?

Yes, of course, usually a feed rate somewhere is set to a low number .0001 .

I would check your retract rate, your lead in/out overrides, other finishing overrides on the multipass and depth cut pages etc...

 

[#Rekd™]

As stated, apply appropriate speeds and feeds to each toolpath and minimize your clearance, retracts etc.