Displaying ONLY WCS axis

[AMCNitro]

IS there a way to display the WCS axis only?  My operators get confused when I hand them the Active Reports setup sheet and both axis are on it.

[crazy^millman]

Yes there is that option in the planes manger and the view ribbon. Sorry out of space to share screen shot. Also pay attention to see if you have the display checked and what is the active plane when making your screen shots. Where Viewsheets help if you need to do a lot of back and forth. 

[AMCNitro]

Found it! Thanks Ron.  ITs going to eliminate a lot of questions and a few mistakes.  

I need to learn about view sheets.

[crazy^millman]

44 minutes ago, AMCNitro said:

Found it! Thanks Ron.  ITs going to eliminate a lot of questions and a few mistakes.  

I need to learn about view sheets.

Yes View Sheets are great. I still think we need a View Sheet manger or them added to planes or the levels manger, but they have come a very long way since their inception. They help us the programmer tell a story and anytime we can take out thoughts and convey them effectively then we have done our job as a programmer.