Post question

[randy]

running mpfan post slightly modifyed on a fortune lathe fanuc controll what i want to do is after a g71 or g72 cycle i need the first line of code to be a goo but its not im tired of hand editing how and where do i modify this im not to experanced with post modification but am willing to give it a shot have my post backed up so what the heck

 

Thanks in advance to the ladies and gentlmen of the form

[CNCGUY]

Do a search for ltlchg.

 

In there look for a line similar to this

code:

---

       pcan1, pbld, n, psccomp, *sgcode, pfxout, pyout, pfzout,

strcantext, e

---

sgcode may be missing or without *

 

Make necessary changes and you should be good.

 

You may also need to add it in ltlchg0 if you rough and finish with the same tool.

 

HTH

[randy]

*sgcode is there still no luck

[CNCGUY]

Note to self -

Read and understand the question before you reply - idiot!!!

 

My bad. I had you looking before the G71.

 

Look here

 

code:

---

 prapidout       #Output to NC, linear movement - rapid

pcan1, pbld, n, psgplane, pexct, psgcode, psccomp, pxout, pyout,

pzout, pcout, pscool, strcantext, e

---

see if you have psgcode in there.

 

[ 04-07-2004, 01:27 PM: Message edited by: CNCGUY ]

[randy]

yes it is there but till post with out g00

this is what i get on line 180

 

N160 G00 Z.06

N165 X-1.0487

N170 G72 W.035 R200

N175 G72 P180 Q190 U0. W0. F.008

N180 Z0.

N185 G01 X.0315

N190 Z.06

 

this is what i want on line 180

 

N160 G00 Z.06

N165 X-1.0487

N170 G72 W.035 R200

N175 G72 P180 Q190 U0. W0. F.008

N180 G00 Z0.

N185 G01 X.0315

N190 Z.06

[CNCGUY]

If you would like to e-mail your post, I will take a look at it and compare with mine.

[randy]

e-mail is down right now will send it to you tommorow

 

thanks

[CNCGUY]

Cool.

[cam-eleon]

You might want to check out the post block "prcc_call_end"

 

 

#Add the finish spindle speed to the first move

speed = n1_ss

pbld, *n, "G1", *string3, e #, *speed,"!!!"

 

 

In my case using mplfan I added a "G1"