Mastercam X5 View Problem

[Faruktepeee]

Hello first of all,

Today, while working on my mastercam x5, I cannot find the places where I can enter the shares that I need to give for face turning and the values that I will use when defining the chuck. So when I open that tab, the image is too big. I cannot see the spaces I will write in the values on the side. I am sending it attached as a photo.

Can you help me?

[#Rekd™]

Since you are using X5 you should contact your reseller as this is likely pirated software.

[CEMENTHEAD]

or...  Alt+Space bar