Corrupt tools warning when exporting operations to ops library

[Thad]

I just exported an operation to my ops library and I got the following message (see image at the bottom of the posting):

I clicked Yes to remove the corrupted tools and the following report popped up.

Quote

230: Surface High Speed (Area roughing) - RF FORM +.005, .187 BALL, PRG
		Tool number:		11
		Tool Name:		.187 ball OSG
		Tool Diameter:		0
		Cor. rad.:		0
		Rad. Type:		Full
		Length Offset:		11
		Diameter Offset:		11
		Spindle Speed:		8000
		Feed rate:		0
231: Surface High Speed (Waterline) - RF FORM +.005, .187 BALL, PRG
		Tool number:		11
		Tool Name:		.187 ball OSG
		Tool Diameter:		0
		Cor. rad.:		0
		Rad. Type:		Full
		Length Offset:		11
		Diameter Offset:		11
		Spindle Speed:		8000
		Feed rate:		0
232: Surface High Speed (Raster) - RF FORM +.005, .187 BALL, PRG
		Tool number:		11
		Tool Name:		.187 ball OSG
		Tool Diameter:		0
		Cor. rad.:		0
		Rad. Type:		Full
		Length Offset:		11
		Diameter Offset:		11
		Spindle Speed:		8000
		Feed rate:		0
240: Surface Finish Blend - FIN FORM, .187 BALL, PRG
		Tool number:		11
		Tool Name:		.187 ball OSG
		Tool Diameter:		0
		Cor. rad.:		0
		Rad. Type:		Full
		Length Offset:		11
		Diameter Offset:		11
		Spindle Speed:		8000
		Feed rate:		0
	#11 - 0.1875 Endmill2 Sphere - .187 ball OSG

	#13 - 0.2500 Endmill2 Sphere - .250 ball

	#17 - 0.2500 Chamfer mill - Harvey 45 chamfer

	#7 - 0.2500 X 20.00 Tap RH - 1/4-20 tap

	#8 - 0.7500 Drill - .750 drill

Since I removed the corrupt tools, I assume I now have ops in my ops library that have no tool assigned to them. Looking through the library, that doesn't appear to be the case, unless I overlooked it.

In the above report, I also assumed that the numbers 230, 231, 232 and 240 would be operation numbers in my library that had corrupt tools. But those numbers don't all match up with operations that use those tools and the ones that do, appear to have a valid tool assigned to them.

So I guess I don't know what to do with all of this. None of this makes any sense. Can anyone shed some light on what's going on here? Using X9.

[gcode]

when I run into this, I decline to delete the corrupt tools

then make new tools and replace the corrupt tools