Doosan 5700 question

[Leon82]

We got a used vmc for free basically and they set it up. I got the auto touch off to work on the OTS but the manual touch just sits there. The GUI says it's executing but there is no movement.

Can it be activated with a g65 macro call or only from the GUI?

[Tinger]

I've had this issue. Had something to do with length offset. Try canceling G49 and then running.

[Paul Anderson]

In fact, the GUI is setup so that it requires 2 presses of the cycle start button. The reason being is in case you do not at first place the tool over the button and 10MM above.

Initiate the cycle, press cycle start. You can't see it but there is an M00 active. Without pressing reset, go to HANDLE mode, move your tool in position, go back to MEM mode and press CYCLE START again. The process will proceed.

[Leon82]

2 hours ago, Paul Anderson said:

In fact, the GUI is setup so that it requires 2 presses of the cycle start button. The reason being is in case you do not at first place the tool over the button and 10MM above.

Initiate the cycle, press cycle start. You can't see it but there is an M00 active. Without pressing reset, go to HANDLE mode, move your tool in position, go back to MEM mode and press CYCLE START again. The process will proceed.

I will try it, thanks