Heidenhain TS460 probe and Productivity+

[MrFish]

Does anyone know if you can get the right output out of  Productivity+ to run Heidenhain probes on a heidenhain controller i.e the onboard probing cycles ?

[Leon82]

i was able to get some of them to work thru drill cycles in mastercam on the tnc530. does it use a post to generate output?

[Aaron Eberhard]

No, it's not really possible.  It's 100% designed around Renishaw cycles.

I'd look into the Cimco probing add on.

[MrFish]

12 hours ago, Aaron Eberhard said:

No, it's not really possible.  It's 100% designed around Renishaw cycles.

I'd look into the Cimco probing add on.

Thanks Aaron, exactly the answer I required, my reseller didn’t know and gave me a fluffy answer !