2 copied ops will not post

[El Scotthead]

Good morning all,

 

I had a problem this morning. I had a toolpass group consisting of 3 ops--surface rough contour, surface finish contour, and surface finish parallel. After cutting the trode, I decided to use a smaller finish endmill. I copied the surface finish contour and parallel toolpasses, picked smaller tool, and regened. I purposely left the original finish contour and parallel passes as semi-finishers.

 

However, only the 3 original passes will post. NCI is same on all 5 ops. Why won't the 2 copied passes post? I worked around it by creating these 2 passes from scratch, but would like to solve this problem.

 

scott

[crazy^millman]

look at your NCI and see that they all have the same name. They might be posting just not to that file is all. Been there done that and stuck my foot in my mouth about doing the same thing.

 

HTH

[El Scotthead]

I've triple-checked that all ops have the same nci path/name--They do. Funny thing I've noticed is that when I highlight the op group, right click, and click on "Change NCI Destination", nothing happens.

 

I put the file on the FTP site, in the "MC9_files" folder. The file is called "Venture1.MC9". Hopefully you will see something I didn't.

 

Scott

[El Scotthead]

OK, so I shut down my computer and left it sit for about 5 minutes. After restart, I still can't right click and change nci path(on this file only, others work fine). But now all ops will post.

 

Any thoughts would still be appreciated though.