Gear problem

[Kannon]

I have just started working with the gear and was wondering if someone could give me a hand.

 

Number of teeth 6

diammetral pitch 36

pressure angle 20.

pitch diameter .1667

outside diameter .239

root diameter .124

circular pitch .0873

circular tooth thickness .052

then the print says..

measurement over (2) .06 diameter pin .2736-.2766

 

I dont know if this is enough information to create this gear I am missing a few of the fill ins that are not on the print can anyone help me

[robk]

I used these your settings... One difference was the pitch dia. It should be .16667

It's enough to create a gear, but don't know if it's what your print calls for.

This is what I got...

[Müřlıń®]

+1 to Robk......roll measurement is in the middle, all is good

[Kannon]

Thanks Robk,

when I type in the exact same numbers I get just a circle! No teeth or anything. Only thing I noticed was in your parameter name you actually have a path. Mine says none. Do I need to purchase the add on, or is the parameter name path the problem?

 

Kannon123

[robk]

Kannon, check your mailbox

[Kannon]

Thanks robk for you extra effort in helping me out!

The gear is on our wire machines as we speak!

[robk]