remainder about simulation CDC

[ak762]

I always use CDC at finish 2D toolpath

How to kill this remainder forever?

I would prefer only as in V9

1520. Display a warning when cutter compensation in control simulation finds an error? y

And I see it's tick at control definition but

this note quite annoying

 

[Slava_6]

I have not understood message of you is: / The Magenta toolpath is only a simulation of the control patch / shows you that you have applied CC in control and as it is not connected with *1520. Y - seem a mistake if this is. N - not show.

[ak762]

Yes, I know that "The Magenta toolpath is only a simulation of the control path." but why this warning message appear every time if I will run additional contour operation. I played with Q1520 Y/N for McamX post but same result. Contrary at Mcam9 only show me Magenta toolpath when I use CDC without warning message

[Thad]

ak,

 

For those windows that keep popping up that I have no other way of stopping them...and they are always the same answer, I use a neat little program called RtvReco. It's a free program that you can set up for any windows program to press buttons, check checkboxes, etc automatically when you always push the same button for certain dialog boxes. It'll click the OK button for you in the blink of an eye and you'll barely see the box pop up. We use it on all of our seats of MC.

 

Thad

[ak762]

Thanks Thad,

Many men many minds. I will try it