Need a lil-help

[Michael1286490636]

I'm running lathe v8.1 and when I set up for either -dz or +dz no matter what I do the ouput is always negative in the x-axis when I run the post. I'm new with this software and problably missing something very easy. Any help would be appreciated.

[gcode]

Michael,

Go to the Job setup page (Alt J)

then Spindle/Turret. Verify the following settings

Horizontal turret lathe (machine type)

Top (Turret)

Left (Active spindle)

If that doesn't fix it you may have a post problem

[Michael1286490636]

OK, here's another question regarding your reply. If I'm running a Gantry type machine, a Hardinge Conquest. I have been using the bottom turret for apps on the front and top turret on the back. Is this correct or should I just stay with the Top turret? Mastercam gives little help in the documentation and everytime I call the dealer they seem reluctant to help.

Thanks,

Michael

[Guest CNC Apps Guy 1]

Michael, dealers may be a bit reluctant to help due to the fact that some resellers are unfamiliar with certain types of equipment. It's hard to be a Master of everthing.

Peronally, I use +DZ for the Top Turret, and -DZ for the bottom turret. Keep it seperated, then add in your wait codes and away you'll go.

JM2C

[ 10-16-2001: Message edited by: James Meyette ]