No more service packs coming out

[gcode]

really high-end high-speed toolpaths /QUOTE]

 

Man, I need those..

I'm woking on a job that turns a 600lb aluminum block into a 28lb aircraft structure. Hign speed would be good

[Müřlıń®]

quote:

---

Man, I need those..

---

Boah yaz!! Needed thoze for a couple years now

[gcode]

Food for thought...

MR1 is going to contain "really high-end high-speed toolpaths" . X no longer ships with Cimco Edit. hmmmm...

[Storkman]

quote:

---

This forum only represents a small (but very important ) cross section of our user base.

---

Yea, but by far the "cream of the crop". cept for a few

[Jeremy Grigsby Excelsior Marking]

no, Todd. I'm talking about the engraving addon. The one that asks you for an access code if you try to use it under toolpaths. I have no problem with the chook thing, I know that takes time. I just want the engraving to work. It kind of worked in the intial release of X, minus small entities that it sometimes didnt chain. In sp1 it doesn't seem to even consider the tool angle, and it doesn't make the corners sharp. I just use that everyday. I still have 9.1 to fall back on so I'm not really complaining, I just was hoping that I could start using X. Its a real improvement for sure. I just have too many things I do alot that take too much time to do this in this program, and do the thing thats not working in the other program. I just don't want to fall behind in learning it. I have to make sure I get my jobs done too.

[Müřlıń®]

quote:

---

X no longer ships with Cimco Edit. hmmmm...

---

Oh ya Now that you mention it....

 

I never used any of that Cimco stuff anyways, proly why I didn't even notice it was gone......

 

I demoed their HSM package though a while back and really liked some of the toolpaths...

 

 

Glad Mastercam is finally doing their own HSM

 

Now if we could get CNC to to some G-CODE verify ......Mastercam would have IT ALL WOOT!

[gcode]

quote:

---

I never used any of that Cimco stuff

---

I use their Cimco Edit. Their new version 5.0

is very good. In fact it's so good I bought a stand alone seat.

 

I've been looking at Cimco's HSM module, and was planning to get a trial license when they released

thier X verison.

 

It will be interesting to see what's in MR1.

[spade117]

so, when all you people updated x did you have to back and change any settings?

[spade117]

I like cimco very much also, but I'm still at version 4.32- but it works very well for me.