Analyze "only"

[gti_jay]

UM...Why can't I chose the type of entity to analyze?

 

***NOTE: I am NOT, not, Not using the pre-select feature.***

 

After I envoke the "analyze" command, the ONLY button is greyed out...

 

ARE YOU GOING TO FIX THIS PROBLEM?

 

P.S. I searched and the only answer was pick your entity first. SEE ABOVE NOTE.

 

[KCollins]

this was covered in pages 5 /6 of the How it works in X thread...i asked the same question...

[gti_jay]

Thanks...I read the thread...

But it doesn't appear to have an "clear" answer.

Just one "work around"

Oh well. I hope CNC will fix this issue.

[Pete Rimkus from CNC Software Inc.]

gti_jay,

 

We're looking at making this improvement in the near future. As you know, you're not the 1st to complain about it.

[Roger Peterson]

I didn't read the thread you talk about but what I do is set my only mask ahead of time and check the box that says "maintain only mask", it works but if you want to change it to only something else you need to exit analyze and reset your only mask.

 

 

HTH