MasterCam Learning Books

[brice]

I was wondering if anyone out there has any suggestions on a MasterCam book that I can buy for our programmers. They need a booking telling them what each switch will do for them. Like what Contour is compared to Flowline etc.....Any Ideas??

 

[Guest]

Check out the books link at the top of this page.

 

Pretty good stuff there.

 

[cadcam]

For that I suggest the Volume series books.

[brice]

Does these books tell you a lot or do they skim over the top of the topics?? I need Version 9 and a baby stepping book for these guys!!

[cadcam]

For that I suggest the Volume series books.

 

Link to book

[cadcam]

This will give you more indepth details of switchs and what nots.

[robk]

IMO you should skip any books that mention the names of Lin and Shiue

[George Hardwick]

Worth giving this a look-

 

http://www.tipsformanufacturing.com

[scoomes]

I just finished Streaming teacher for mcx and it was great. well worhtthe 240 dollars but it only teaches mill level 1 and doesent cover surfaces.I think that I will look to my supplier for surface training$$$$$$$$$$$..Check out Streamingteacher.com

Scott

[Jeremy Haage from MCAM NorthWest]

scoomes,

 

We will begin to create surface training for the Mastercam X courseware on Streamingteacher.com beginning with the new surfacing toolpaths that will be included in Mastercam X MR1. We just created a new block in the table of contents that will focus on all of the changed or new functionality brought into play by service packs and maintenance releases. We'll have a segment to focus on the changes in SP1 and we will have the new surface toolpath training up there when MR1 releases. We've also started to expand into Surface/solid geometry creation so you will see more additions on those topics in the future.

 

Jeremy