high speed toolpaths...Misc ints not sticking

[El Scotthead]

This only occurs on the new high speed toolpasses. Was wondering if anyone else has noticed it/brought it to CNC's attention.

 

I enter something into misc int #1, hit Apply, then hit the green check. On opening the toolpath again, misc int #1 is back to 0. As a matter of fact, all misc ints do this. I have to manually edit the code after posting. No big deal, but I'm absent-minded sometimes, and don't realize it until after the program's loaded into the machine.

 

scott

x mill lvl 3 MR1

[crazy^millman]

As a fix for now could you hard code the post for highspeed. I know it sucks becuase you then have to have a post for highspeed with the machine configue and your regular post but that might be a work around for now.

 

HTH

[El Scotthead]

That's exactly what I'll be looking into in a few hours, when I get a little breather. Any input/suggestion would be appreciated, as I only know enough about posts to be dangerous. I'll get it, but I'll have to fumble around for a while. Thanks for the quick reply.

 

scott

[Bill Craven]

If you set the defaults in the number section of the post and then check the "automatically set to post values when posting" (under the Miscellaneous values of the high speed toolpaths), It seems to post correctly. This should work until they get this sorted out.

[El Scotthead]

Thanks, Bill,

 

its a work around. I'm still gonna try to modify my post, so I don't have to remember to change the work offset in the code each time.