1017 Line

[tsewyek]

Good Morning everyone,

I'm using Mill V9.2 and trying to transform a pocket cycle by coordinates, but I keep getting the error,"Construction Plane In Operation Does Not Match It's 1017 Line!". I've deleted it, redone it, reset my Tplane & Cplane and redone it with the same results, Any help or insight into this problem of mine would be greatly appreciated!

 

Thanks In Advance!!

[DavidB]

quote:

---

I'm using Mill V9.2

---

I'd like to see that

[Kannon]

if you want to put it up on the ftp, or sent it to my way unzipped I would be happy to take a look

[tsewyek]

For Some reason as of late I have been unable to access the FTP site and I have not had the time to investigate why.

[Kannon]

can you send it to me unzipped?

[Kannon]

DavidB,

Did you draw a blank?

[DavidB]

It's 9.50 Sat night to many bourbons mate. Posted in the wrong thread sorry

[tsewyek]

All that I drew was the outside contour of the part at B90 & B270 with and Island in the middle and a point to make entry. There are four parts arranged vertically 1.89 apart, when I create the pocket toolpath on either side of the part and try and transform it by coordinate to the othe locatiosn I get the error. It's not a big deal as I've worked around it and created the toolpaths necessary, Iwould just like to know what caused it to begin with.