regenerating toolpaths

[Mike@Dive Lab Inc.]

Hey guys, I have a simple part I have ran before and it woked fine. I needed to change cutter size and when I do I says incorrect parameter and locks up. i redrew the file, a simple polygon 8 sided .250 deep. Now whenever I change DOC, multipass,lead in/out it does not show a dirty toolpath. When I try to verify it then says its dirty and doesn't seem to be changing anything?? still using MR1

[Mike@Dive Lab Inc.]

I think I got it, started over with a new file a few times and it seems to be working

[Hardmill]

Can I see you orig. file ??

 

 

PEACE

[Mike@Dive Lab Inc.]

I already saved the new file over it. Also when I'd try to close it I got a message that there was a active command, there was not, then I'd have to do a ctr=alt=del

 

it's working o.k. now

 

thanks