Posting feedrate problem

[cncfrank]

Hey All: Hopefully there is an easy place to fix this. I have started programming using G95, which is feedrate per rev. I was able to change the post to output only G95's, but if my feedrate is under .01, I get a posted feedrate of F.0 . Where can I find that issue in the post, to allow the feedrate to be more that 1 decimal point.

 

Thanks all

Frank

[New Job]

My guess would be to check the format of the variable used to output that feedrate.

 

HTH

[cncfrank]

How do I find the variable ?

[Guest]

code:

---

fmt  F  18  feed        #Feedrate

---

Make sure it's set to 18 as it is above

[cncfrank]

Works Great ! Thank you. I did notice though on a tap feedrate it goes 7 places past the decimal. But if it can't be fixed I can live with that. Thanks again John.