Program # will not post no matter

[shazam/TPP]

which post processor i use. i modified the mpmaster post and it's been working fine in x2mr1

but since this update it'll just post out Ooooo.

i ran the chook update and it made no difference.

here is my post code:

 

"%", e$

spaces$=0

n$, *progno$, " (", sprogname$, ")", e$ #added n$,

n$, " (MFG DWG-", sprogname$,")", e$ #NEW LINE

n$, " (X ZERO IS )", e$ #NEW LINE

n$, " (Y ZERO IS )", e$ #NEW LINE

n$, " (Z ZERO IS )", e$ #NEW LINE

spathnc$ = ucase(spathnc$)

smcname$ = ucase(smcname$)

comment$ # File descriptor

spaces$=0post code

 

 

[crazy^millman]

Are you 100% sure you have a program number on the program?? Right click on the 1st operation and be sure there is a number there. Sometimes people add an operation an assume the program number is put in where it is not you have to put it not saying that is the case here, but should work unless there is a force 0000 statement somewhere in the post which I have seen people do why I do not know, but I have seen it done.

 

HTH

[shazam/TPP]

boy am i a dumb a$$ or what? don't answer that. talk about a huge brain fart thanks Ron.

[crazy^millman]

Don't fell bad I have done it more than once Why do you think I knew what to tell you???