nethasp problem

[holden]

Help, having problems with nethasp saying licenses in use when no one is on mastercam.

Hasp is located in IT deparment on server,they will reboot server and it will correct problem but I have to get them to do it every day,(pain in butt)

First time asking question here but have used info here.

 

 

running mastercam x22 mill3,solids, wire and

pro-e converter

[Guest]

They may want to make sure they are running the latest server software, if it remains a problem there is a License Manager utility that can be installed which allows a restart of the license manager to free up the licenses without having the reboot the server

[holden]

Thanks for repling I will ask about server software ,but i'm sure they most likly are as the IT deparment is abig deparment here at medtronic ,as far as rebooting thats what they are using is license manager utility.ed holden

[kinglouie V]

Doesn't hurt to point them in the right direction.

[Greg_J]

What server vesrion are they on? I have the same problems with the licences.

 

I am using 8.3.

 

It has gotten drastically worse sence I installed X3, especially on the Lathe. It's been at least 5 crashes this morning and it wont let go of the licence so I have to reboot the server computer.

[holden]

I don't know which version ,but was wondering if maybe running different versions (x2,x22)us or in your case maybe(x22 & x3 )is causing problems with nethasp.

[gcode]

Using different versions at the same time can cause nethasp problems.

I can open 2 or three sessions of one version

and it will use one license.

If you start mixing your versions you will check out a license for each version that you open

Open V9 and X3 at the same time and you'll check out 2 licenses