Z Feed with no movement

[Robert Bell]

Just installed X3 MU1. Was using MR2 SP1 on older comp, bought new laptop to start using X3.

Imported MMD files, solved a few issues.

I now have a Z axis feed rate posting by itself on a line with no movement.

 

 

G0 Z.06

X.5924 Y-.7454

Z-.257

G1 Z-.282 F3.5

X.6019 Y-.7831 F9.

F3.5

X.6366 Y-.9215 F9.

X.5194 Y-.8401

F3.5

X.4875 Y-.8179 F9.

G0 Z.06

 

I have searched and searched for this and came up empty. I know its has to be simple, just cant find it.

 

No high low feed issues, any help would be greatly appreciated

 

Haas 4x mill post

 

Thanks in advance

[gcode]

If you are using an mpmaster post, check out the locked thread 2nd from the top.. older mpmaster

posts need a couple of tweaks to run in X3

[Robert Bell]

I checked that out first and none of the 17000 series numbers in table are close to what i saw in my post. I then (after posting ?) checked my old machine and it was doing the same thing. I feel like an idiot now but still am curious as to why this is happening. I noticed max depth var in paramaters is set to .005 same as my cut depth but it is also blanked out-unable to change. I dont think thats it.

 

Thanks for the reply, you have definitely helped me a lot learning MC

[gcode]

Robert,

there is a solid Haas post in the

the X3 install.

C:McamX3millpostsGeneric Haas 4X Mill.pst

give it try

[Colin Gilchrist]

Robert,

 

Check your control definition settings. Under the Linear tab are your radio buttons set to "break rapid moves" or "break all moves with change in _"?

[Robert Bell]

gcode, i will try that as soon as i can, off to dinner. I will have to try to get that off the disk as i am pretty sure i overwrote it with my own from x2.

 

Colin G, all 3 buttons set to "break rapid moves"

 

tnx